1.Control indicator -Comes on when the remote
control sends a radio signal when the key are pressed.
When the indicator lblinks only weakly , the batteries
have to be replaced.
2. Arm - Switches on the Security System in the Arm
Away Mode. All sensors are activated.
3. Disarm - Switches off the Security Systemt.
4. A on/off - Switches on/off the lights connected to the
Lamp Module set to the Home Automation Base
Address.
5. B on/off -Switches on/off the lights connected to the
Lamp Module set to the Home Automation Base Adress
+1.
6/7. Panic -When both keys ARM(2) and DISARM(3)
are pressed simultaneously, an immediate alarm is
initiated by the Security System. (NOTE! ON KR21E Press the both
reed key simultaneously).
8. Battery holder - The back of the remote can be easily opened by
taking the two parts apart. Use Cr2016 (2xCR2016, 3V lithium
batteries.
Using the Key Chain Remote Control
A new Kr18 contains batteries for default. INITIALIZING THE
KR18:Press the ARM key for more than 3 seconds and release the
button; the indicator blinks. Release the button.The remote control has
now chosen a unique code, which can be registered with your console.
When pressing the Arm button the LED should flash quickly a few times. When the LED lights up and stays lit,
you need to re-initialiaze the KR18.
Registering the Key Chain Remote Control with the Console
1. To access the menu, press either the menu upp or down button. The display now shows ENTER PIN.
2.Enter your 4-digit PIN code (facyory setting 0000). The display is cleared and shows a * for each number
entered.
3. When the PIN code has been entered correctly, the word INSTALL will show up on the display.
4. Press OK. The display now reads INSTALL ZONE.
5. Press the ARM button on your key chain remote control. The console will beep to confirm. The display will read
RMOT 1 SET.If you have more than 1 remote control installed, it will show e.g. RMOT 2 SET, RMOT 3 SET.
- RMOT 16 SET. You can register up to 16 remote controls.
6. Repeat step 5 for every remote control you wish to register.
7. Press CLEAR to go back to the first menu item. Press CLEAR again to quit the menu. To confirm your choice,
press 1 for Yes or 2 for No. If you choose Yes, you will quit the menu. If you choose No, you go back to the first
menu item.You can also remove remote controls from the menu e.g when you have lost a remote control(page 12)
.
Key Chain RemoteKey Chain Remote
5
1
2
4
6/7
KR21E
KR18E
3
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji